Glass Spray Dryer for Laboratory

*Harga yang di coret adalah harga normal
*Harga yang tertampil adalah harga hari ini
*Dapatkan tambahan Special Promo pada hari-hari tertentu hubungi kami.


Glass Spray Dryer for Laboratory

Type : LAB-1
Changes liquid to be powder
– Suitable for single phase or three phase power supply.
– Spray Dried powder can be collected under cyclone as Single Point Discharge or optionally under chamber and cyclone as Two Point Discharge system. This gives flexibility to check particle size under chamber and cyclone.
– Drying Chamber and Cyclone are made from Glass for visual observation of the process.
– GMP / Pharmaceutical standards are observed in manufactured like avoiding crevasses , smooth finish ,guards provided for electric motors, use of food Grade Silicon Gaskets etc.
Specification :
– Water evaporation capacity : 1.0 – 2.0 kg/ hr
– Feed rate with 30% solid content w/w : 1.5 kg/ hr
– Powder rate : 0.5 kg/hr
– Inlet Temperature : Ambient to 260 deg C max
– Outlet Temperature : 60 – 100 deg C
– Flow between spray and hot gas : Two Fluid Compressed Air Nozzle System
– Method of powder collection :
“Blown Down” powder collected under the cyclone – Single Point Discharge and alternatively Two Point Discharge i.e. Under the cyclone and chamber
– Material of construction :
SS AISI 316L / 304 / Borosilicate Glass Original 2B finish on the plates and weld lines ground smooth to 180 grit sanitary design.
– Material of Drying Chamber :
Glass Cylinder; Borosilicate glass; annealed- stress Relieved- spark tested two piece construction for ease of cleaning. Powder removal in Assembly

+ Top and bottom cones in SS 316L
– Atmospheric pressure : 760 mm Hg
– Ambient temperature : 30-40 deg .C Relative
– Location of installation : Indoor

Utility List :
1. Electric Power Source ; Motor : 230V single phase or 440 V, 3 phase
Instruments : 230 V, single phase,50 Hz
2. Electric List (Installed), Feed Pump : 0.50 HP, Exhaust Fan : 1.00 HP
3. Other Utilities
– Power Requirement for Electrical Air Heater : 5KW
– Space Requirement (L x W x H) mm : 1200 x 1300x 2000
– Weight of the unit : 150 Kgs
PLC operating system for spray dryer with HMI mounted on plant for operation.


There are no reviews yet.

Be the first to review “Glass Spray Dryer for Laboratory”

Your email address will not be published. Required fields are marked *